Mose schreef:
Ja, dat klopt. Welke moet ik dan precies hebben? Ik heb nu 'show minimal messages'.
Zie dit bericht nu pas sorry.
Ik heb een andere versie (testversie) van TrunkView dan jij hebt dus kan het niet precies één op één uitleggen.
Heb nog wat meer info vwb de HEAD (tekst) berichten.
If a radio unit on a control channel receives a HEAD message with PFIX1/IDENT1
matching its individual address then it shall respond with the appropriate acknowledgement
(see below), with PFIX/IDENT1 as its individual address and IDENT2 set to IDENT2 from
the HEAD. The HEAD address codeword contains a field (LEN) which indicates the
number of appended data codewords; the unit shall respond in the slot following the last
data codeword. For timing, see 6.2.1.3.
a.
If the unit is not equipped to accept the data messa
ge then it shall send ACKX
(QUAL=0).
b.
Otherwise, the unit shall send one of the following acknowledgements:
ACKB (QUAL=1) if not all the appended data codewords were decodeable
and the unit requires the message to be retransmitted
or
ACKX (QUAL=1) if it cannot accept the message at this time e.g. its data
store is full)
or
ACKV (QUAL=1) if it does not wish to accept a data message from this
calling party
or
ACK (QUAL=0) if it has accepted the data message.
If a radio unit on a control channel receives a HEAD message with PFIX2/IDENT2
not matching its individual address, and
PFIX1/IDENT1 matching one of its group addresses for this system or
IDENT1 set to the system-wide all-call ident ALLI,
then it may accept the information contained in the HEAD address codeword and the
appended data codewords, but shall transmit no response.